User Tools

Site Tools


guide:nrf24multiprotocoltx

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
guide:nrf24multiprotocoltx [2016/11/11 20:57]
cmengler
guide:nrf24multiprotocoltx [2016/11/11 23:09]
cmengler [Steps]
Line 14: Line 14:
   - Layout the Arduino Nano on the PCB prototype board (e.g. top most left).   - Layout the Arduino Nano on the PCB prototype board (e.g. top most left).
   - Layout the nRF24L01 transceiver module on the PCB prototype board (e.g. top most right of Arduino Nano).   - Layout the nRF24L01 transceiver module on the PCB prototype board (e.g. top most right of Arduino Nano).
-  - Wire **3.3V** from Arduino to nRF24L01 **VCC** pin.+  ​- Wire up the pins for the transmitter. 
 +    - Wire **GND** from both Arduino and nRF24L01 to **GND** pin of transmitter. 
 +    - Wire **VIN** from Arduino to **+BAT** pin of transmitter. 
 +    - Wire **D2** from Arduino to **PPM** pin of transmitter. 
 +  - Wire the pins from the Arduino to the nRF24L01 transceiver module. 
 +    ​- Wire **3.3V** from Arduino to nRF24L01 **VCC** pin. 
 +    - Wire **D3** from Arduino to nRF24L01 **MOSI** pin. 
 +    - Wire **D4** from Arduino to nRF24L01 **SCK** pin. 
 +    - Wire **D5** from Arduino to nRF24L01 **CE** pin. 
 +    - Wire **A0** from Arduino to nRF24L01 **MISO** pin. 
 +    - Wire **A1** from Arduino to nRF24L01 **CSN** pin.
  
 +//TIP: For connection to the external RF pins on the transmitter,​ you could use a 4-pin servo cable instead of the 2.54mm pitch female headers.//
 ==== Pin-outs ==== ==== Pin-outs ====
 ^Arduino^nRF24L01^Transmitter^ ^Arduino^nRF24L01^Transmitter^
guide/nrf24multiprotocoltx.txt · Last modified: 2016/11/18 22:33 by cmengler