This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
guide:nrf24multiprotocoltx [2016/11/11 23:05] cmengler [Steps] |
guide:nrf24multiprotocoltx [2016/11/11 23:10] cmengler [Parts] |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| * 1x nRF24L01 transceiver module | * 1x nRF24L01 transceiver module | ||
| * 1x 4cm x 6cm PCB prototype board | * 1x 4cm x 6cm PCB prototype board | ||
| + | * 1x 2.54mm female connector header row //(optional)// | ||
| * 26 AWG wire | * 26 AWG wire | ||
| Line 25: | Line 26: | ||
| - Wire **A0** from Arduino to nRF24L01 **MISO** pin. | - Wire **A0** from Arduino to nRF24L01 **MISO** pin. | ||
| - Wire **A1** from Arduino to nRF24L01 **CSN** pin. | - Wire **A1** from Arduino to nRF24L01 **CSN** pin. | ||
| + | |||
| + | //TIP: For connection to the external RF pins on the transmitter, you could use a 4-pin servo cable instead of the 2.54mm pitch female headers.// | ||
| ==== Pin-outs ==== | ==== Pin-outs ==== | ||
| ^Arduino^nRF24L01^Transmitter^ | ^Arduino^nRF24L01^Transmitter^ | ||
