This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
guide:nrf24multiprotocoltx [2016/11/11 23:05] cmengler [Steps] |
guide:nrf24multiprotocoltx [2016/11/18 22:33] (current) cmengler [References] |
||
---|---|---|---|
Line 8: | Line 8: | ||
* 1x nRF24L01 transceiver module | * 1x nRF24L01 transceiver module | ||
* 1x 4cm x 6cm PCB prototype board | * 1x 4cm x 6cm PCB prototype board | ||
+ | * 1x 2.54mm female connector header row //(optional)// | ||
* 26 AWG wire | * 26 AWG wire | ||
Line 25: | Line 26: | ||
- Wire **A0** from Arduino to nRF24L01 **MISO** pin. | - Wire **A0** from Arduino to nRF24L01 **MISO** pin. | ||
- Wire **A1** from Arduino to nRF24L01 **CSN** pin. | - Wire **A1** from Arduino to nRF24L01 **CSN** pin. | ||
+ | |||
+ | //TIP: For connection to the external RF pins on the transmitter, you could use a 4-pin servo cable instead of the 2.54mm pitch female headers.// | ||
==== Pin-outs ==== | ==== Pin-outs ==== | ||
^Arduino^nRF24L01^Transmitter^ | ^Arduino^nRF24L01^Transmitter^ | ||
Line 39: | Line 42: | ||
===== References ===== | ===== References ===== | ||
* https://github.com/goebish/nrf24_multipro/blob/master/README.md | * https://github.com/goebish/nrf24_multipro/blob/master/README.md | ||
+ | * https://www.rcgroups.com/forums/showpost.php?p=34414371&postcount=3376 |