User Tools

Site Tools


guide:smokestopper

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
guide:smokestopper [2016/04/08 08:46]
cmengler [How to build the SmokeStopper]
guide:smokestopper [2016/05/25 19:02] (current)
cmengler [Steps]
Line 1: Line 1:
-====== How to build the SmokeStopper ======+====== How to build SmokeStopper ======
 SmokeStopper,​ a light bulb as a current-limiting device to provide power to a device under test. The wattage of the light bulb is chosen such that if there'​s a dead short in the device under test, instead of allowing massive current to flow and letting out the Magic Smoke, the bulb will glow and only the amount of current needed to illuminate the bulb will flow. This only needs to be enough to allow the device to initialize; not enough for it to operate at full power. SmokeStopper,​ a light bulb as a current-limiting device to provide power to a device under test. The wattage of the light bulb is chosen such that if there'​s a dead short in the device under test, instead of allowing massive current to flow and letting out the Magic Smoke, the bulb will glow and only the amount of current needed to illuminate the bulb will flow. This only needs to be enough to allow the device to initialize; not enough for it to operate at full power.
  
Line 5: Line 5:
  
 ===== Parts ===== ===== Parts =====
 +{{ :​guide:​smoke_stopper_parts.jpg?​400 |}}
 +
 +  * 1x 12v 20w halogen or suitable globe
 +  * 1x XT60 male connector
 +  * 1x XT60 female connector
 +  * 1x 10cm 14-12AWG wire (black, negative)
 +  * 2x 15cm 14-12AWG wire (red, positive)
 +  * 6x heat shrink pieces
 +
 +//NOTE: 12v 20W globe will limit the current to ~1.6A, this is generally enough to power up a quadcopter with FPV gear (and maybe idle motors).//
  
 ===== Steps ===== ===== Steps =====
 +  - Solder and heatshrink one length of the red wire onto the positive XT60 male connector.
 +  - Solder and heatshrink one length of the red wire onto the positive XT60 female connector.
 +  - Push one leg of the 12v globe into one length of red wire and solder and heatshrink, repeat using the remaining red wire and other leg of the 12v globe.
 +  - Solder one length of the black wire from the negative XT60 male connector to the negative XT60 female connector.
  
 +{{ :​guide:​smoke_stopper_complete.jpg?​400 |}}
  
 ===== References ===== ===== References =====
   * http://​www.rcgroups.com/​forums/​showthread.php?​t=2327875 (credit: mnemennth)   * http://​www.rcgroups.com/​forums/​showthread.php?​t=2327875 (credit: mnemennth)
guide/smokestopper.1460069202.txt.gz ยท Last modified: 2016/04/11 20:52 (external edit)