This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
guide:smokestopper [2016/04/10 22:25] 127.0.0.1 external edit |
guide:smokestopper [2016/05/25 19:02] (current) cmengler [Steps] |
||
---|---|---|---|
Line 5: | Line 5: | ||
===== Parts ===== | ===== Parts ===== | ||
- | * 1x 12v 20w (at minimum) halogen or suitable globe | + | {{ :guide:smoke_stopper_parts.jpg?400 |}} |
+ | |||
+ | * 1x 12v 20w halogen or suitable globe | ||
* 1x XT60 male connector | * 1x XT60 male connector | ||
* 1x XT60 female connector | * 1x XT60 female connector | ||
* 1x 10cm 14-12AWG wire (black, negative) | * 1x 10cm 14-12AWG wire (black, negative) | ||
* 2x 15cm 14-12AWG wire (red, positive) | * 2x 15cm 14-12AWG wire (red, positive) | ||
- | * 6x heat shrink peices | + | * 6x heat shrink pieces |
+ | //NOTE: 12v 20W globe will limit the current to ~1.6A, this is generally enough to power up a quadcopter with FPV gear (and maybe idle motors).// | ||
===== Steps ===== | ===== Steps ===== | ||
+ | - Solder and heatshrink one length of the red wire onto the positive XT60 male connector. | ||
+ | - Solder and heatshrink one length of the red wire onto the positive XT60 female connector. | ||
+ | - Push one leg of the 12v globe into one length of red wire and solder and heatshrink, repeat using the remaining red wire and other leg of the 12v globe. | ||
+ | - Solder one length of the black wire from the negative XT60 male connector to the negative XT60 female connector. | ||
+ | {{ :guide:smoke_stopper_complete.jpg?400 |}} | ||
===== References ===== | ===== References ===== | ||
* http://www.rcgroups.com/forums/showthread.php?t=2327875 (credit: mnemennth) | * http://www.rcgroups.com/forums/showthread.php?t=2327875 (credit: mnemennth) |