This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
guide:smokestopper [2016/04/11 18:36] admin |
guide:smokestopper [2016/05/25 19:02] (current) cmengler [Steps] |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| * 6x heat shrink pieces | * 6x heat shrink pieces | ||
| - | //NOTE: 12v 20W globe will limit the current to ~1.6A, this is generally enough to power up a quadcopter w/ FPV gear (and maybe idle motors).// | + | //NOTE: 12v 20W globe will limit the current to ~1.6A, this is generally enough to power up a quadcopter with FPV gear (and maybe idle motors).// |
| ===== Steps ===== | ===== Steps ===== | ||
| + | - Solder and heatshrink one length of the red wire onto the positive XT60 male connector. | ||
| + | - Solder and heatshrink one length of the red wire onto the positive XT60 female connector. | ||
| + | - Push one leg of the 12v globe into one length of red wire and solder and heatshrink, repeat using the remaining red wire and other leg of the 12v globe. | ||
| + | - Solder one length of the black wire from the negative XT60 male connector to the negative XT60 female connector. | ||
| + | {{ :guide:smoke_stopper_complete.jpg?400 |}} | ||
| ===== References ===== | ===== References ===== | ||
| * http://www.rcgroups.com/forums/showthread.php?t=2327875 (credit: mnemennth) | * http://www.rcgroups.com/forums/showthread.php?t=2327875 (credit: mnemennth) | ||
