This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
pidflightlap:ethernet [2018/06/10 09:49] cmengler |
pidflightlap:ethernet [2018/06/10 10:05] cmengler [How to setup Ethernet module for lap timing device] |
||
---|---|---|---|
Line 7: | Line 7: | ||
{{ :pidflightlap:pidflightlap_enc28j60_shield.png?400 |}} | {{ :pidflightlap:pidflightlap_enc28j60_shield.png?400 |}} | ||
- | - Flash the PIDflight Lap Ethernet firmware to the Arduino Nano to be used for the ENC28J60 Ethernet Shield. Refer to [[pidflight:flashingfirmware|Flashing firmware to lap timing device]], same process applies for flashing HEX files to Arduino. | + | - Flash the PIDflight Lap Ethernet firmware ({{:pidflightlap:pidflightlap_ethernet_0.0.1.zip|Download}}) to the Arduino Nano to be used for the ENC28J60 Ethernet Shield. |
- Configure your PC wired network connection.<code> | - Configure your PC wired network connection.<code> | ||
Static IP: 192.168.4.60 | Static IP: 192.168.4.60 | ||
Line 15: | Line 15: | ||
- Connect the Ethernet module to the first (or only) lap timing device. Refer to pin-outs. | - Connect the Ethernet module to the first (or only) lap timing device. Refer to pin-outs. | ||
- | ==== Pin-outs ==== | + | ===== Connecting to the GUI app ===== |
+ | - Establish network connection. | ||
+ | - Open the GUI lap timing app. | ||
+ | - Select 'Manual selection' from the drop down menu. | ||
+ | - Enter ''<nowiki>tcp://192.168.4.1:23</nowiki>'' in the 'Ports' field.{{ :pidflightlap:pidflightlap_gui_tcp.jpg?nolink |}} | ||
+ | - Click 'Connect'. | ||
+ | |||
+ | ===== Pin-outs ===== | ||
^Arduino^Ethernet Arduino^ | ^Arduino^Ethernet Arduino^ |