This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
pidflightlap:ethernet [2018/06/10 09:50] cmengler [Pin-outs] |
pidflightlap:ethernet [2018/06/10 10:05] cmengler [How to setup Ethernet module for lap timing device] |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| {{ :pidflightlap:pidflightlap_enc28j60_shield.png?400 |}} | {{ :pidflightlap:pidflightlap_enc28j60_shield.png?400 |}} | ||
| - | - Flash the PIDflight Lap Ethernet firmware to the Arduino Nano to be used for the ENC28J60 Ethernet Shield. Refer to [[pidflight:flashingfirmware|Flashing firmware to lap timing device]], same process applies for flashing HEX files to Arduino. | + | - Flash the PIDflight Lap Ethernet firmware ({{:pidflightlap:pidflightlap_ethernet_0.0.1.zip|Download}}) to the Arduino Nano to be used for the ENC28J60 Ethernet Shield. |
| - Configure your PC wired network connection.<code> | - Configure your PC wired network connection.<code> | ||
| Static IP: 192.168.4.60 | Static IP: 192.168.4.60 | ||
| Line 14: | Line 14: | ||
| </code> | </code> | ||
| - Connect the Ethernet module to the first (or only) lap timing device. Refer to pin-outs. | - Connect the Ethernet module to the first (or only) lap timing device. Refer to pin-outs. | ||
| + | |||
| + | ===== Connecting to the GUI app ===== | ||
| + | - Establish network connection. | ||
| + | - Open the GUI lap timing app. | ||
| + | - Select 'Manual selection' from the drop down menu. | ||
| + | - Enter ''<nowiki>tcp://192.168.4.1:23</nowiki>'' in the 'Ports' field.{{ :pidflightlap:pidflightlap_gui_tcp.jpg?nolink |}} | ||
| + | - Click 'Connect'. | ||
| ===== Pin-outs ===== | ===== Pin-outs ===== | ||
