This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
pidflightlap:wifi [2017/08/16 11:18] cmengler [DT-06] |
pidflightlap:wifi [2017/08/16 11:21] cmengler |
||
---|---|---|---|
Line 6: | Line 6: | ||
By default the DT-06 module is set to **9600** baud rate and TCP port **9000**. The DT-06 module must be configured to **115200** baud rate. | By default the DT-06 module is set to **9600** baud rate and TCP port **9000**. The DT-06 module must be configured to **115200** baud rate. | ||
- | - Ensure your DT-06 is connect to the Arduino Nano. | + | - Power up the lap timing device with the DT-06 module connected. |
- | - Power up the lap timing device. | + | |
- Connect to the WiFi network (by default it will be called "Doit_WiFi_XXXXXX"). | - Connect to the WiFi network (by default it will be called "Doit_WiFi_XXXXXX"). | ||
- Open your web browser to **http://192.168.4.1** {{ :pidflightlap:dt-06_main.png?direct&360 |}} | - Open your web browser to **http://192.168.4.1** {{ :pidflightlap:dt-06_main.png?direct&360 |}} |