This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
pidflightlap:wifi [2017/08/16 11:18] cmengler [DT-06] |
pidflightlap:wifi [2017/08/16 11:21] cmengler [DT-06] |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| By default the DT-06 module is set to **9600** baud rate and TCP port **9000**. The DT-06 module must be configured to **115200** baud rate. | By default the DT-06 module is set to **9600** baud rate and TCP port **9000**. The DT-06 module must be configured to **115200** baud rate. | ||
| - | - Ensure your DT-06 is connect to the Arduino Nano. | + | - Power up the lap timing device with the DT-06 module connected. |
| - | - Power up the lap timing device. | + | - Connect to the WiFi network, by default it will be called "Doit_WiFi_XXXXXX". |
| - | - Connect to the WiFi network (by default it will be called "Doit_WiFi_XXXXXX"). | + | |
| - Open your web browser to **http://192.168.4.1** {{ :pidflightlap:dt-06_main.png?direct&360 |}} | - Open your web browser to **http://192.168.4.1** {{ :pidflightlap:dt-06_main.png?direct&360 |}} | ||
| - Navigate to **Module** -> **Serial**, set the **BaudRate** to **115200** {{ :pidflightlap:dt-06_serial.png?direct&360 |}} | - Navigate to **Module** -> **Serial**, set the **BaudRate** to **115200** {{ :pidflightlap:dt-06_serial.png?direct&360 |}} | ||
