This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
pidflightlap:wifi [2017/08/16 10:53] cmengler created |
pidflightlap:wifi [2017/08/16 11:38] (current) cmengler [DT-06] |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| By default the DT-06 module is set to **9600** baud rate and TCP port **9000**. The DT-06 module must be configured to **115200** baud rate. | By default the DT-06 module is set to **9600** baud rate and TCP port **9000**. The DT-06 module must be configured to **115200** baud rate. | ||
| + | - Power up the lap timing device with the DT-06 module connected. | ||
| + | - Connect to the WiFi network, by default it will be called "Doit_WiFi_XXXXXX". | ||
| + | - Open your web browser to **http://192.168.4.1** {{ :pidflightlap:dt-06_main.png?direct&360 |}} | ||
| + | - Navigate to **Module** -> **Serial**, set the **BaudRate** to **115200**. {{ :pidflightlap:dt-06_serial.png?direct&360 |}} | ||
| + | - Navigate to **Module** -> **WiFi**, you can optionally change the **SSID Name** and **Password**. {{ :pidflightlap:dt-06_wifi.png?direct&360 |}} | ||
| + | - Navigate to **Module** -> **Networks**, set **Socket Type** to **TCP Server** and **TCP Server Local Port** to **23**. {{ :pidflightlap:dt-06_network.png?direct&360 |}} | ||
| + | - Navigate to **More** -> **Restart**, for settings to take affect the DT-06 module must be restarted. | ||
| + | - All done! | ||
| + | |||
| + | ==== Pin-outs ==== | ||
| + | |||
| + | ^Arduino^DT-06^ | ||
| + | |5V|VCC| | ||
| + | |GND|GND| | ||
| + | |RX|TX| | ||
| + | |TX|RX| | ||
| ===== ESP01 serial adapter ===== | ===== ESP01 serial adapter ===== | ||
| //To be completed.// | //To be completed.// | ||
